Centos 7 partitions Raid1 five pieces, when the screw is pulled out it does not boot, how to configure?

Question

RAID

Actually, the problem is that if I make 3 partitions mdadm raid 1
/boot
/
/swap
, then everything is loaded, but if I add two more raid 1 on the same disks, then if I pull out one disk, the system marks two partitions as inactive upon reboot and emergency is loaded Maud.
Actually, I did not understand what is the reason for this behavior.
I see the outputs like this, do not make a separate section under the boot, and then it will be possible to make at least one additional section for the data. Or mark the entire disk for raid 1 and only then make partitions on it, but I don’t know how to do it correctly.
What do you advise ?

Answer 1

But - outside the array.
Everything else is in the array, which is described in the config

Answer 2

reason found https://www.linux.org.ru/forum/admin/11994055?cid=...