What does the raid controller want from me?

Question

RAID

Good day!
I set up monitoring on the Adaptec 6805E raid controller.
raid10 array.
In case the discs start to bend, some kind of signal is needed.
The built-in utility has sending a letter via smtp.
The letter comes. But there is sadness. (Not Supported) What does the controller want from me?
" ADAPTEC BY PMC EMAIL NOTIFICATION MANAGER (Coalesced)
======================================= ============================================
Event Type : Informational
Event Source : [email protected] Notification Manager
Date : 08/24/2015
Time : 01:15:23 AM GMT+03:00
-------------------------------------------------- -------------------------------------------------- --------------------------------------------
Event(s) List With Description
------ -------------------------------------------------- -------------------------------------------------- -------------------------------
August 24, 2015 1:14:22 AM GMT+03:00 INF 423:A --CS--L-- Alfa Drive map: controller 1, channel 0, SCSI device ID 4, controller 1 ( Adaptec 6805E #4A4413974C9 Physical Slot: 2 ), channel 0, SCSI device ID 4, S/N 50026B723A0343CF (Vendor : KINGSTON Model: SV300S37A480G) Controller 1 Controller 1 Not Supported
August 24, 2015 1:14:22 AM GMT+03:00 INF 423:A--CS--L-- Alfa Drive map: controller 1, channel 0, SCSI device ID 4, controller 1 ( Adaptec 6805E #4A4413974C9 Physical Slot: 2 ), channel 0, SCSI device ID 4, S/N 50026B723A0343CF (Vendor: KINGSTON Model: SV300S37A480G) Controller 1 Controller 1 Not Supported
"

Answer 1

should be:
- event levels (warning/attention/failed - for example)
- and the events themselves for each level (disk dump / array dump / controller temperature exceedance / bad smart, etc.)
configure which levels and what to send