Replacing the motherboard on a laptop

Question

Do it yourself

There is a laptop with a non-working motherboard and there is a working motherboard of the same series and model.

Is it possible to change it yourself, because for sure it is more difficult than in a conventional computer.

Answer 1

Take an A4 sheet and a pencil. Unscrew the bolts, lay them out on the sheet, respectively, as they were screwed into the laptop. Use a pencil to mark the trains and details. Several layers of bolts - several sheets.
This is how I disassembled the hp laptop (there were a lot of bolts).

Answer 2

lmgtfy.com/?q=hp+touchsmart+tm2+disassembly :)

Answer 3

As a beginner in this business, I disassembled only two laptops: one (dell) was successful, and one (toshiba) was not very good (teared off the touchpad cable), I dare say that it’s easier to give 500 rubles. and I’ll take everything apart for you, clean it, assemble it, and in a lot less time than you carry yourself.

Answer 4

Nothing overly complicated. We carefully disassemble the laptop, disconnect all cable connectors (remembering where they were), pull out the mother, put a new one. We return all the cable-bolts back. I soldered connectors and other elements on one of my laptops. I disassemble each of my laptops, but as a rule, after about a year of operation. Clean it up, at the very least.

Answer 5

In fact, there is nothing complicated there. Most likely, the monitor does not have to be detached, just disconnect the cable connecting it to the mat. payment. The most difficult thing that will happen there is not to confuse (do not forget) what to stick where, but as already written above, a pen and a pencil can solve this :)

Answer 6

If you write what kind of spherical laptop you have in a vacuum, it will be much easier to give recommendations.

Answer 7

how many times have I disassembled / assembled laptops, it won’t work to stick something in the wrong place, the only problem is, some bolts are of different lengths and it’s easy to screw them in the wrong place, and then wonder why the other one doesn’t screw

Answer 8

I would personally take the familiar admins along with a couple of bottles of beer.
But if you really want to do it yourself, it shouldn't be difficult. The main thing is to do everything carefully, do not lose any screws and in any case do not exert extra effort when removing the pieces of iron.

Answer 9

Be sure to take a camera and photograph every detail from all angles before disassembling.
If this is not done, then, according to the law of meanness, some kind of wire will surely fall off the board. It will not be possible to guarantee without photos that you will solder it in the right place.