Keenetic Giga + Ubiquiti NanoStation. How to be?

Question

Computer networks

Good evening, dear habrazhiteli!
I have this problem: The
provider in our village provides access to the Internet via Wi-Fi. In my absence, they installed the equipment and left, the Internet worked.
The scheme is as follows: Central Wi-Fi - Ubiquiti NanoStation - ethernet - WAN Keenetic - Wi-Fi to home devices.
And here I come. I need to set up network printing, on the machine I try to get into the admin panel of the router at the usual address and stumble upon the tightly locked NanoStation admin panel. In short, I thought that it would be nice to set everything up myself, especially since NanoStation itself gives settings via cable (I checked it on a computer). So, I reset the router settings and began to configure it.
I set everything to receive automatically (as a computer) - it does not work.
Enabled in the computer - wrote off the settings from there:
DHCP is enabled: Yes
IPv4 address: 192.168.1.2
IPv4 subnet mask: 255.255.255.0
IPv4 default gateway: 192.168.1.1 IPv4
DHCP server: 192.168.1.1 IPv4
DNS server: 192.168.1.1
Service NetBIOS over TCP/IP enabled: Yes
Still not working. Pings don't work.
In the admin panel of the router, this is the situation:

Help me solve the problem, this must be done urgently, because tomorrow I'm leaving and I will leave the house without the Internet ...
Thank you in advance!
Provider - TeleGlobal, if it matters

Answer 1

From what is immediately wrong - the WAN and LAN interfaces have the same network 192.168.1.0/24. Try setting a different address range for your home network. If this does not help, then you will not get rid of contact with the support service, most likely PPPoE or PPTP was configured.

Answer 2

maybe for WAN MAC another was driven in