Is it possible to shape traffic inside the bridge using Mikrotik?

Question

Computer networks

There is a gateway to the Internet 192.168.1.1, a switch and subnet 1.0/24 are connected to it, eth1 is included in the same switch with the address 192.168.1.2. In eth2, Mikrotik has a switch and a dozen more machines on the same subnet. eth1 in bridge with eth2. It is necessary to limit the traffic of these machines, but Mikrotik does not see it point-blank until you turn on NAT, then the guys from above do not see the guys from below. Where is the joint?

Answer 1

In the properties of the bridge, turn on the firewall, then mark the necessary traffic in the firewall, and hang braids on the marked traffic.
wiki.mikrotik.com/wiki/TransparentTrafficShaper

Answer 2

>bridge > settings > use ip firewall