How to add hardware raid 10 in already installed Windows Server 2016?

Question

RAID

Hello!
Server on motherboard P5BV-C/4L
2 LSI Logic & Marvell controller raid on LSI
- raid 10, Marvel - raid 1 ... During installation, Windows was able to install drivers only on Marvell. Then successfully installed Windows. How do I now add raid 10 from LSI to the system? In Device Manager, Storage Controllers tab, both raid controllers are identified. But I don’t understand how I can now add a disk to the system. Drivers from Marvell were also only for Server 2008, but they came up, but from LSI they didn’t want to install during installation, that is, they were found but not installed. Finally solved the problem like this
, I read the manual for the motherboard again and remembered that in parallel with the LSI there is an Intel raid controller, I switched the jumper on the motherboard and voila, the raid was determined immediately, I didn’t even have to install the driver.

Answer 1

Have you looked into disk management ?
ps

In Device Manager, Storage Controllers tab, both raid controllers are identified

do you have a gui?

if yes, then

if console then diskpart
pps

I downloaded drivers for raid controllers from the website https://www.asus.com/us/Commercial-Servers-Worksta...

there is neither win10 nor sideboard 2016. that is, there are no compatible firewood along the way,
try searching for the type

https://drp.su/en/catalog

искать лучше всего по строке как на скрине найти такую строку можно в свойствайх устройства, в том же диспетчере устройств. и при выборе источников, старайтесь выбирать оффсайты а не помойки