Can it be cured?

Question

Iron

Good day. There is kingston skc300s37a/120g. lived less than a year. no guarantee.
symptoms: when the computer is turned on cold, it is determined and calmly determined in the OS. however, after 1 - 10 minutes, it just cuts off (disappears from the device manager, the bios also does not see if you just load the computer, but if you turn off the power completely and turn it on again, at least immediately, the broom is again detected and works from 1 to 10 minutes). If you just restart the computer, then the ssd is not seen either in the BIOS or in the OS. It doesn't matter if the wasp is loaded from this broom or another - the result is the same.
On other iron checked working capacity - too most.
formatting, OS change - nothing.
if you have time to quickly load kingstontools while the broom is being determined, then it writes the state good 91%, everything is OK by smart.
is it curable? what it is? how to proceed?
thanks in advance
UPD thanks everyone for the replies, went for a new ssd

Answer 1

No.

Answer 2

Try contacting Kingston itself. They are now very responsive to work, maybe lucky.
They lost the warranty from the store. The manufacturer can at least recommend something.

Answer 3

If the drive is cut off and it is re-detected only after a cold start, then there are multiple errors either inside the disk controller or when communicating with the computer - you excluded the second (I hope the sata cable was changed?), then the first, and this is not treated. Try to replace without a receipt, for example, if the order number is saved (in the same personal account of the store).

Answer 4

not treated, I have the same one for 60GB, everything is ok, but the recording is jerky and loads percent when deleting a bunch of small files,
this is an excellent illustration for the right choice of controller and for discounts on Amazon for the Black Friday type

Answer 5

In principle, if desired, sandforces are well restored. Of course, they do not become more reliable from this, and the wear of the nanda does not go away.
Much worse is the situation with the old indilinx for example.

Answer 6

Warm up the controller with a blow dryer. 50/50 chances