Arduino not flashing what to do?

Question

Arduino

WAVGAT Arduino Uno R3
CH340g
here is the error:
Arduino: 1.8.13 (Windows 7), Board: "Arduino Uno"

The sketch uses 924 bytes (2%) of the device's memory. A total of 32256 bytes are available.

Global variables use 9 bytes (0%) of dynamic memory, leaving 2039 bytes for local variables. Maximum: 2048 bytes.

avrdude: stk500_recv(): programmer is not responding avrdude

: stk500_getsync() attempt 1 of 10: not in sync: resp= 0x7c : resp=0x7c avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x7c





avrdude: stk500_recv(): programmer is not responding avrdude

: stk500_getsync() attempt 4 of 10: not in sync: resp= 0x7c : resp=0x7c avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x7c avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 7 of 10 : not in sync: resp=0x7c avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x7c avrdude: stk500_recv(): programmer is not responding










avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x7c

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x7c Board

loading problem. Download help : www.arduino.cc/en/Guide/Troubleshooting#upload .

This report will have more information with File -> Preferences -> "Show verbose output during compilation"
option enabled

Answer 1

Try to change the usb cable, check which board you are uploading the firmware to, go to the tools where you need to select the processor, see the appropriate one with the inscription old, try with it