Why is the parameter not being written to the APC1000VA eeprom?

Question

System administration

I use the utility from apcupsd.org to monitor the status and correctly shut down the APC Smart-UPS1000VA (III generation). I configure the correct shutdown and inclusion of the UPS. Changed in the UPS eeprom, through the apctest utility, the parameters "shutdown delay" (delay until the UPS is turned off, after a signal is given to turn off the server), and "wakeup delay" (delay until the UPS is turned on after power is restored). I'm doing a test: "shutdown delay" works fine (changed from 180 seconds to 540), and "wakeup delay" is reset to the standard value - 60 seconds (I set 300 seconds). Why?

Answer 1

Along the way, there really is a problem in the windows software, because there is no such problem with the linux software. I will write to support