Where can I get a DIY case for Raspberry?

Question

Do it yourself

Hey!
There is a small Raspberry project that includes several sensors, a screen and a keyboard (4x4 button matrix).
I searched the net and did not find where you can get suitable cases. Most interested in the case for the matrix keyboard. I don't have a 3D printer :(

Answer 1

I don't have a 3D printer :(

So it is necessary to turn to those who have. A bunch of offers for commercial 3D printing

Answer 2

You have four options:
1. Simple and cheap. Throw this rotten idea and buy this device ready. Pros: Save money and time. Cons: Boring, not our method, in short.
2. Simple and expensive. Assemble a 3D printer and print what you need. Pros: you will have your own 3D printer. Cons: You need to kill a lot of money and time.
3. Complicated and expensive. Buy: approximately-approximately suitable body and finish it to the desired condition. Pros: Good fun, much cheaper and faster than item 2. Cons: Everyone needs money (perhaps even more than in paragraph 1) and you will not have a 3D printer.
4. Complicated and cheap. Glue the plexiglass case (for example, boxes of old CDs). Pros: Well, very cheap and cheerful. Cons: Hemorrhoids are still the same and the printer, again, will not be

Answer 3

If it weren't for the keyboard, I'd suggest shrink wrap. Budget case. I took temperature monitoring devices in cabinets that look very good.

Answer 4

Pharmacies sell the so-called. pillbox. Square and rectangular 100-200 r / pc. I make cases for crafts on it. Inside - cut through the walls, along the height and on the sides - put and glue a gasket from which God sent!