Trassir swears at camera settings, would you know what?

Question

CCTV

In general, there are two series of hikvision cameras and a Trassir surveillance server. Exclamation marks appear in tracer settings on some cameras. On the ds-2cd2142fwd-is series, settings higher than device specifications are lit at all, but it does not say which ones. On the ds-2cd2122fwd-is series, it constantly writes needs reboot on two, but reboot does not help. What is happening to him? Camera firmware is up to date.

Answer 1

Try to enable/disable cameras from the tracer interface + change resolutions, quality, accompanied by reloading cameras after changes.
I had this after updating the cameras and the tracer, in different firmware different "templates" are wired.
In general, they have a good TP, they can fix it remotely if you create a ticket

Answer 2

Looks like hickeys are buggy. I would try to pick up on RTSP and look at the behavior.

Answer 3

Everything turned out. Tried the settings. It turned out that some have 4mp resolution and cif 25fps. Dropping down to 20fps on the substream helped where FHD resolution was set, and dropping down to FHD helped where it was 4mp. Thanks Sergey .