Set up Plymouth with Nvidia drivers?

Question

linux

Good afternoon,
I tried to set up a splash screen for myself when starting the axis using Plymouth, I set it up according to this guide (however, where I found solutions in other places - the same steps are described everywhere). Because drivers from nvidia are, then after the first step of installation and configuration, nothing happened. I moved on to the next step, which describes the setting when using proprietary firewood, and here the problems started on this command:

# cat /sys/bus/platform/drivers/uvesafb/uvesafb.0/vbe_modes | sort

because the uvesafb0 directory is simply missing.
There is only this:

$ ls /sys/bus/platform/drivers/uvesafb/
bind    module/ uevent  unbind  v86d

Here I was already alert, but continued to follow the rest of the steps. It seems like I did everything according to the manual, only at the moment when the system starts, a splash screen appears, it loads for a while, then the screen saver itself disappears, but the loading indicator (spinning "sun") remains. And on top you can see the console output and the following is written sobsno:

kernel: uvesafb: Getting VBE info block failed (eax=0x4f00, err=0)
kernel: uvesafb: vbe_init() failed with -22
kernel: uvesafb: probe of uvesafb.0 failed with error -22

And then nothing happens. The system starts only in Recovery Mode.
How can I fix this problem and make it work?