No communication between HP MSR2003 and Cisco 2960-X, what could be the problem?

Question

Computer networks

The bottom line is, I configured 10 Wealans on the HP router, the second port was transferred from the port link-mode route state to the port link-mode bridge state.
Transferred the port to the trunk, drove the necessary wilans there. On a tsiska he created Wealans, transferred the port to a trunk, he threw Wealans. But there is no connection between devices, even poppies are not visible.
On HP, I returned the port to the port link-mode route state, assigned an IP address. I created an arbitrary wealan on the switch, made an IP address from the router's network, connected it, each other's devices perfectly see and ping ....
What's the problem? How to set up correctly? Perhaps there is some cherished command on the HP miracle router to make everything work ... can someone tell me?

Answer 1

Show the port settings of both switches.

Answer 2

and advice for the future: "You shouldn't build heterogeneous networks, because then you won't end up with problems." It is better to use equipment from one vendor.