Need help with 3D printing. how to set up the printer?

F

Fill Full2019-04-01 10:35:25

3D

Fill Full, 2019-04-01 10:35:25

Hello. I need help with the XYZPrinting da Vinci Junior 2.0 printer. The printer was bought for school and, accordingly, no one worked with it. And today I decided to print plugs for alloy wheels. I found a 3D model on the Internet, adjusted it to size. printing. all problems can be seen in the photo. Question: what should I do so that the part does not slip? and how to solve my problem? I googled it seems like this error is due to old plastic? and in general I will be glad to hear your advice on 3D printing topics.
https://drive.google.com/file/d/1njF1cCBf6svksjVed... <--- there are pictures)

Reply

Answer the question

In order to leave comments, you need to log in

2 answer(s)

N

Nikolai, 2019-04-01
@hiddenSt

The photo is not clear. It's like printing on a piece of cardboard. You need to set the temperature of the table heating, calibrate the printer. Sometimes the printed part is not attached to the table, then masking tape, some types of hair sprays are used. I use regular glue stick. Here is a good site: https://3dtoday.ru
And here are the most models: https://www.thingiverse.com

E

evgeniy_lm, 2019-04-01
@evgeniy_lm

What does "didn't slip" mean? Are you putting down a piece of paper? The rest of the photo is not clear the essence of the problem. Describe in more detail.
Personally, I glue the detail to the glass with cheap hairspray. I tried PVA and glue stick turns out worse.
In fact, if no one has used the printer, you should first calibrate it, download several calibration models (cubes, boats, etc.), print them in different modes, at different speeds, with different materials. Perhaps, according to the results of the tests, the firmware will need to be adjusted, if everything is in order with the print sizes, in any case it is useful to know the capabilities of the printer