Morotik setup, how to bridge Wlan1 with intranet and VirtualAP in bridge with WAN?

Question

Mikrotik

Good afternoon. The question of how to implement the following scheme is of interest:
1. Wlan1 is bridged with ports 2-5
2. VirtualAP is connected to the "provider" network
That is, some clients must connect to Wlan1 and receive an address from DHCP Mikrotik, and some clients connect to VirtualAp and get the address from the DHCP "Provider".

Answer 1

You need to create a separate bridge, add the provider port and VirtualAP to it. The IP settings of this bridge must be made the same as on the provider's port.

Answer 2

To begin with: the provider gives you an ip, which takes the Mikrotik for itself and then natit LAN. Are you sure that the provider gives/gives you more than 1ip-address?
And so: create 2 bridges: in the first, all ports except wan and the wlan1 interface, in the second - virtual ap and wan, hang dhcp-client on the 2nd bridge