How to set up an HP 2610 switch?

O

other_letter2015-04-03 13:46:06

Computer networks

other_letter, 2015-04-03 13:46:06

...I'm sitting here and I can't even start.
There is a switch, it works. You can do anything with it, that is, resetting the config is not a problem.
Alas, there is no cable for the console.
His IP is unknown.
I read a manual - type by default it takes the address from DHCP. OK, resetting the config. I look at DHCP (it is on the 2003 server) - there are no new addresses.
I start MyLanViewer, I scan the entire network and in addition the most likely subnets 192.168.0.x and 192.168.1.x are empty.
What else can be done?

Reply

Answer the question

In order to leave comments, you need to log in

2 answer(s)

V

Valentin, 2015-04-03
@vvpoloskin

Some port on the switch is still managed. Since there are only 10 of them, you can put Wireshark on a laptop and dump all ports one by one, after disconnecting all other services from the switch. Sooner or later you will see DHCP or ARP requests, possibly with a VLAN. This will be the control port. Another point, you still don’t have a login and password (
the easiest way is to reset it to zero and set it up according to the instructions.

S

Sergey, 2015-04-03
@edinorog

quote exactly how to reset to factory settings pzh