How to set up a transparent Mikrotik bridge?

Question

Computer networks

there are two Mikrotik LHG5 points . the task is to set up the bridge. Roughly speaking, this bridge should replace a twisted pair cable. the first point will be connected to the modem, the second to the router, on which PPPoE will already be raised. there are a lot of instructions on the Internet on how to make a Point-to-Point bridge, they differ mainly in the fact that someone writes that you need to turn on WDS, someone writes that it is not necessary.

in general terms, I set it up like this

Передающая
1) Создаем bridge
2) суем в него LAN и WLAN
3) Вешаем на этот бридж адрес
4) Настраиваем WLAN как bridge, протокол nv2
Принимаемая
1) Создаем bridge
2) суем в него LAN и WLAN
3) Вешаем на этот бридж адрес (я вешаю из той же подсети, что и Передающая точа)
4) Настраиваем WLAN как station bridge, протокол nv2, авторизация и т.п.

With this setting, the Internet can only be obtained if the first one is connected to a router that already has Internet. Then the beech connected to the second one receives the IP of the received point via dhcp (from the subnet of the second point, not the IP of the router) and has access to the Internet.
And if I connect the provider's cable directly to the first point and want to raise the PPPOE after the bridge, then this does not work.
Does anyone have an option for some other setting? So that the beech connected to the bridge sees only the port of the router to which the first point is connected, but does not see the points themselves

Answer 1

And what is the problem?
On both sides, raise the bridge between wlan and ether1, on the side of the distributing point, set the bridge mode, on the side of the client point, set the station bridge mode.
The provider is not a Rostelecom case? We had such that pppoe stopped rising through the bridge (not Mikrotikovsky), Rostelecom could not say what the problem was, it was decided to leave the router raising pppoe on the provider's side