How to make Zalman ZM-VE500 see new images?

Question

Hard disks

Good day. There is such a thing. Zalman ZM-VE500.
I didn’t see the images after the purchase, but the instruction admin-pawwwel.blogspot.com/2017/09/zalman-zm-ve350 helped...
I used the device for a while, I didn’t know trouble, exactly until I had to add images to _iso folder. And that's it. The images that are already there work great, but the new ones are not visible in any way. I updated the firmware to 2.02, but it did not help. Completely merge the data from the screw, format it again and upload it back every time a new image is needed, the desire is zero.
Has anyone faced a similar problem?

Answer 1

Capricious this Zalman, and too expensive. I had two or three of them at different times, repaired them more than once: bad soldering, the legs of the microcircuit on the board bounce off the tracks. In the end, I spat, now I use the Ventoy utility, it makes a multi-boot disk from any external USB drive: you throw the necessary .iso to the root (not necessarily to the root, you can go to any directory), and boot from the selected one. Images are written to disk by simple copying, as in Zalman (and this is much more convenient than fiddling with the YUMI program, for example), and when loading the desired image, the desired image is selected from the menu on the computer display, approximately like in YUMI (and this is an order of magnitude more convenient than move them with the joystick in the case of Zalman). This is not an answer to the question, but advice for the future: do not mess with Zalman boxes. Check out www.ventoy.net.

Answer 2

There was a similar problem. Found a solution here