How to determine the position from which the BGP protocol starts in an MPLS packet?

I

I

irdr2020-05-20 01:17:25

Border Gateway Protocol

irdr, 2020-05-20 01:17:25

How to determine the position from which the BGP protocol starts in an MPLS packet?

How to find out the exact position in the data stream from which the BGP protocol starts, if the packet type is MPLS, and after the mpls header, both the ip protocol and the ethernet header can go, etc. I can’t figure out how to find out the packet length before the start of the BGP protocol from this .

Reply

Answer the question

Answer the question

In order to leave comments, you need to log in

0 answer(s)

Similar questions

S

SunToLife2017-02-10 12:38:07

What mechanism to use for fault tolerance when BGP to ISP? 0Reply

V

Vladislav Tatarintsev2021-03-10 22:26:10

BGP Mikrotik how to send a specific network through a specific provider? 1Reply

V

v-ex2015-04-27 19:18:49

How to set up NAT on Mikrotik via BGP? 3Reply

C

Cyril2017-07-27 17:38:59

Where can I read in detail about OSPF and BGP? 1Reply

N

Nik2015-08-28 03:25:19

Why do I have a ping to addresses in one visit for some addresses goes to some does not go? 5Reply

Didn't find what you were looking for?

Ask your question

Ask a Question

731 491 924 answers to any question