How to connect wifi client to LAN without NAT on DD-WRT micro?

A

Aleksey Kuzmin2014-08-19 17:35:37

Network administration

Aleksey Kuzmin, 2014-08-19 17:35:37

Hardware: Linksys WRT54G2 v1.0
Firmware: DD-WRT Micro
I want Linksys WRT54G to be a client in the WIFI network and this network was on the LAN switch.
So far, it has only been possible to connect the Wi-Fi interface of the client (I have eh1) to the WAN.
The Internet works, but through NAT.
Is it possible to directly link WIFI-client and LAN in DD-WRT?
And How?
WIFI-client is selected in the WIFI settings.
thank.

Reply

Answer the question

In order to leave comments, you need to log in

1 answer(s)

A

Aleksey Kuzmin, 2014-08-20
@AlekseyKuzmin

the solution is found in the manual :)
There are two modes
1. WIFI-client - in order to connect WIFI to WAN and get a different subnet at the output. Useful if we connect to a public fifayu.
2. WIFI-client-brige - just for my task. A vlan0 and eth1 bridge is created - thus we have the same network on the LAN as wifi