How to clean the system unit from dust?

Question

Computers

There is a lot of dust in the system unit, including on the boards. How to clean it?

Answer 1

Vacuum cleaner + brushes.

Answer 2

1. brush off the coked dust
2. collect with a vacuum cleaner
3. open the stickers on the fans and put a drop of engine oil
on the steps 1 and 2 can be successfully completed when you come to the tire shop, where the compressor will blow everything out.

Answer 3

A brush helps a lot, even a vacuum cleaner, even a hair dryer or a balloon.
But!!! Take a brush made of natural fiber, just in case. Statics.

Answer 4

If you are afraid of vacuuming, you can try a can of compressed air or an old toothbrush.

Answer 5

Disassemble and ordinary household vacuum cleaner?

Answer 6

Aesthetic tips with a vacuum cleaner and a brush are fine, but technically it only makes sense to clean the fans.

Answer 7

I liked blowing dust with air from a spray can ... Right now I'm thinking about buying a compressor for an airbrush (1-2 atmospheres) ... I would also like to figure out how to combine a gun from a compressor and a vacuum cleaner so that the blown dust is immediately sucked into the vacuum cleaner (well, at least part of it) :-)

Answer 8

In addition to the spray can, it is very convenient to use a pump for “frog” type mattresses - with a nozzle with a narrow hole it gives an excellent powerful jet. Usually I take it out to the balcony or another good draft - and all the dust is quickly picked up by the air flow.

Answer 9

Women's hair dryer (for someone men's) is the best thing for blowing dust + brush!

Answer 10

Here is a habrapost about a can of compressed air to clean the system unit from dust. I immediately remembered the name of Alexander Belyaev's novel "The Air Seller")))) Defender - air seller)

Answer 11

In my practice, the most extreme tool was the compressor. Fast, efficient and the computer even seemed to work later =)

Answer 12

Heh, learn physics, you can't blow out all the dust with a vacuum cleaner of any power :)
On the topic - disassemble and wash.

Answer 13

Blow-out vacuum cleaner and brush)

Answer 14

I blew it with a dryer with cold air, at the same time I held the vacuum cleaner to collect all the dust. I also used a car compressor (the one that is pedal-operated) with nozzles for hard-to-reach places.
After he removed the boards, cleaned them with a brush (like a squirrel), wiped those with alcohol.
Some engine oil dripped into the fans