How to allow RDP access to a routed network on Kerio Control?

Question

Network routing

Hello. A similar question.
There is a main local network on a separate network interface 10.10.0.0, traffic from networks 192.168.1.0, 192.168.2.0, etc. is directed to it through the routing table. It is required to allow RDP access to computers in routed networks, but I just can’t figure out how the forwarding rule to routed networks should look like. Everything works on Kerio Control 9.2.5 build 2532. Many
thanks in advance.

Answer 1

Yes, everything seems to be done there. In the traffic rules, make a rule where you specify the source where the requests will go from (usually this is a network interface), specify the Firewall or a separate network interface (if you have it separately) as the destination, specify port 3389 in the services. and allow access - that's it.
If you need to redirect to some specific IP, then in the same rule specify the Broadcast and port.
And so, for clarity, a screen of network and routing in Kerio as configured would not hurt.