Arduino Bluetooth HM-10. How to force update?

Question

Arduino

I connected the HM-10 Bluetooth module to the Arduino, everything started.
Then I decided to update it, and switched it to the AT update mode with the command.
I launched the bootloader, but it could not connect and I accidentally closed it.
As a result, the module is in update mode, but it can no longer be connected to it and it does not respond to AT commands.
Is there any way to force it to update?
The module itself is

Answer 1

Try to make it a "hard reset" - according to the datasheet, you need to find the RST pins or something like that and apply a level / ground to it.

Answer 2

"Hard reset" did not help, it turned out that the firmware had flown somehow. uploaded again according to the guide from the forum of the site