Will this repeater work?

Question

network hardware

There was an urgent need to connect two adjacent buildings. Rather, they are connected, but the connection speed is 100Mb, and the connection is built on stupid switches.
We replaced the root switch on the second building and the intermediate one. But as it turned out, from the root router, to the intermediate switch, there is a category 5 cable, 180 meters long (I was in shock when I measured it) and 1G did not work, only 100Mb.
It is not possible to move the intermediate switch closer to 1 case. We will do it, we still need to raise the trunk, but now there is not enough 5e cable available.
So the question is whether the repeater is suitable www.nix.ru/autocatalog/networking_trendnet/TRENDne...
For this connection scheme:
Mikrotik CCR1036-12G-4S-EM <-> Repeater <-> hp 1910-8G
I note that the installed equipment of the third level and vlans are organized between them.
UPD
I repeat The question - is it possible to put this repeater between mikrotik and hp 1910-8G, on such a scheme, provided that vlan will function on the line, and aggregation (when I draw the second line)?

Answer 1

Support answer.
Good afternoon.
Your request has been forwarded to an authorized PCC service center.
Accordingly, the TPE-E100 works as a regular repeater, that is, no problems should arise, the maximum length of the network, when using several repeaters, is up to 300 meters, this should be enough for your project.

Answer 2

So you need a swarm on one side and an additional cable 100 long