Why won't the Unifi AC-LR hotspot start?

Question

WiFi

Good afternoon. The situation is as follows
. I purchased 2 access points unifi AC-LR
I installed the controller, the controller sees the point, I start to fasten the points to the controller, they seem to be configured, but after that something incomprehensible happens. On the controller, it says that the point is disabled, the point itself is not available by ip, the light indication is as follows: It shines white, then it starts blinking white, at the moment of blinking white, blue color is added 1 time, after it blinks white again and turns off, then all over again. It seems that the point stupidly cannot boot, I changed the firmware on the points and the version of the controller, both higher and lower. the behavior of the points is the same everywhere.

Answer 1

I had a similar canoe - I downloaded the controller application to my phone, scanned the qr code, and set it up from the phone.

Answer 2

In general, I bought 2 UAP AC LR points, connected to the existing controller - everything was fine, a week later I got into the controller, I see the buttons - upgrade, well, I pressed it, the points fell out. those. you reset, adobe is active, supposedly starts to connect ... and the disable status falls out. What I did: reset it, then connected directly from the laptop via IP (default) 192.168.1.20, downloaded the firmware, uploaded it via Wincaps, updated it via Putti, everything !!!! connected-plows! used this article trakrd.ru/2018/12/12/nastrojka-ubiquiti-unifi-ap-po-ssh