Why is the link not rising on the Cisco 5508 wireless controller ports?

Question

Cisco

Is Cisco 5508 wireless controller sfp GLC-T modules are inserted into it. I can’t figure out what and where to include in order for them to work. Patchcords of them are plugged into the switch. On ports writes all the same link down The
piece of iron new nothing is configured plainly yet.
Tell me where to dig?
(Cisco Controller) >show port summary
STP Admin Physical Physical Link Link
Pr Type Stat Mode Mode Status Status Trap POE SFPType
-- ------- ---- ------- ------ ---- ---------- ------ ------- ------- ----------
1 Normal Disa Enable Auto Auto Down Enable N/A 1000BaseTX
2 Normal Disa Enable Auto Auto Down Enable N/A 1000BaseTX
3 Normal Disa Enable Auto Auto Down Enable N/A 1000BaseTX
4 Normal Disa Enable Auto Auto Down Enable N/A 1000BaseTX
5 Normal Disa Enable Auto Auto Down Enable N/A Not Present
6 Normal Disa Enable Auto Auto Down Enable N/A Not Present
7 Normal Disa Enable Auto Auto Down Enable N/A Not Present
8 Normal Disa Enable Auto Auto Down Enable N/A Not Present

Answer 1

Check that the connection is 1Gb, if it is plugged into 100Mb, it will not rise and will not write anything in the logs.

Answer 2

maybe
ports in shutdown then

service unsupported-transceiver
no errdisable detect cause gbic-invalid

may need to
reload

Answer 3

What modules are you using? If not-Cisco, then with a high probability it will not rise, see what is written to the log. There is no service unsupported-transceiver command on the WLC.