Categories

JavaScriptPHPHTMLCssPythonWordPressWeb developmentLinuxMySQLAndroidWindowsJavaC++ / C#LayoutReactUbuntuYiiDjangoProgramming1C-BitrixLaravelSystem administrationTelegramJSONDebianPostgreSQLIOSGoogleHtaccessWindows ServerGitMacOSGoogle ChromeCMSWooСommerceBootstrapNginxSQLUnityAPI
Make a leaderReport
L
L
littleguga2016-06-28 19:00:52
Asterisk
littleguga, 2016-06-28 19:00:52

What ports need to be opened in Asterisk when using res_pjsip and why?

I googled something, but I did not find information about the list of ports used (maybe I was looking for it wrong).

Reply
Answer the question

Answer the question

In order to leave comments, you need to log in

1 answer(s)
Report
D
Dmitry Shitskov, 2016-06-28
@Zarom

Ports are specified in configuration files. By default,
SIP: 5060
The RTP range is specified separately in rtp.conf

Similar questions
S
Sergey Ryzhkin2017-03-05 13:31:05
Asterisk and externaddr where should it show up? 2Reply
D
Denis Verbin2015-03-06 20:38:53
How to forward 3G modem in Vmware VM? 2Reply
B
bagos2017-03-14 10:17:56
Is it possible to forward a call from a home phone to an external phone via asterisk? 1Reply
K
karibskii_koks2017-03-17 10:55:41
How to play an audio file in Asterisk if the lines are busy? 3Reply
D
DizZa2017-03-19 03:23:13
In FreePbx, a non-outgoing trunk always shows Registered, even if the password is incorrect. How so? 1Reply

Didn't find what you were looking for?

Ask your question

Ask a Question

731 491 924 answers to any question