Manual addressing?

Question

System administration

So. We have a Mikrotik router. Working subnet 1.x The first port leads to the outside. Vneshka goes to the provider through a bridge of two yubikov. On top of this pppoe to the internet. And then it suddenly turns out that the types of yubikov duplicate active addresses from the working subnet. It would be necessary to rewrite this rukozhopstvo on a separate subnet. But to do this, you first need to get through to them. I understand how to do this from within the network. How to do it from outside? Need ideas.

Answer 1

Specify the route to <IP-ubik>/32 in microt to lead through the external interface. It will be more specific route, respectively, the router will have to use it.

Answer 2

Temporarily change the internal network of Mikrotik. Customize your skirts. Reset Mikrotik settings

Answer 3

You can try to put a label on external traffic from your IP (or on a certain incoming port), natit it and then route it to yuubiki using this label.