Is it worth taking the KYOCERA ECOSYS M2030dn MFP?

Question

MFP

They offer hand (second-hand) MFP KYOCERA ECOSYS M2030dn. It is said to have been used very little.
Is it worth taking such a model for the accounting department? Or would you recommend something else?

Answer 1

Kyocera M2030dn is a good office model.
If she was treated normally, then on a non-original toner she should leave 75-80 thousand sheets without problems. The number of prints can be seen on the test page (if not reflashed, of course). After 75 thousand, you will need to contact the service center so that they clean it, clean the mining bunker, and work on.
Common problems:
after about 100,000 prints, the paper pick rollers will need to be replaced;
after 150 thousand prints, most likely, the question will arise of replacing the main node with a service kit (half the cost of a new device).
The original toner, presumably, should increase the life of the device, but it will also cost significantly more.

Answer 2

I dealt with M2035dn, but this one is about the same.
A good device, you can take it if it is in working condition.
True, it seems to have already been discontinued, there may be problems with consumables, check if they are on sale.
If there were no kiosers before, then as consumables they have not only a cartridge (which is just a can of toner in the kioser), but also a photo roller, which is enough for about 3-5 cartridge changes.