Is it possible to protect against rescanning on a biometric controller?

Question

Time Management

Good afternoon.
I will install a biometric controller to control the working time of employees by fingerprints.
Is it possible to set a time interval during which an employee cannot be re-identified? That is - the user marked with a finger - the device beeped - everything is OK, "the user has come" .. And the user misunderstood - they marked him or not - and he poked his finger again - and the system immediately considered that he had left. It doesn’t roll over time intervals, anti-re-identification is needed, say, for 10-20 seconds. Yes, maybe his hands are trembling and his finger was held there twice ... So that it doesn’t turn out so that he came and immediately left. Tell me if Anviz M5 has the ability to configure, or which software has a similar function.
Thank you.

Answer 1

Skud solutions are ready-made solutions. You should be consulted where you took the equipment. Of course, biometric SDKs have such possibilities, there are any possibilities at all since it is an SDK, but of course, this is development.