How to transfer the rules to Mikrotik (from a working cat 2900)?

Question

network hardware

Hello, there was a need to replace the working cisco 2900 with mikrotik RB4011iGS. Now I'm hastily digging into the configuration, there were plugs. The grid seems to have been raised, but it does not work with the Internet and IPsec. Can you tell me how to translate the config correctly?
I configure not in combat mode, through Winbox.
Gags happened with ip nat pool my-pool
ip route
not sure how to convert them to microts
Here is a piece from the cat
!
interface FastEthernet0
ip address xxx.xxx.xxx.114 255.255.255.248 on wan interface)
!
ip route 0.0.0.0 0.0.0.0 xxx.xxx.xxx.113 (I put this part in Mikrotik through IP-routes, adding the rule Dst. Address 0.0.0.0/0 Gateway 212.34.42.113, Check Gateway ping Dist. 1)
!
ip nat pool my-pool xxx.xxx.xxx.115 xxx.xxx.xxx.115 netmask
255.255.255.248 provider