How to make a slot on the board in Proteus?

R

Roman Popov2019-11-11 15:56:42

Printed circuit boards

Roman Popov, 2019-11-11 15:56:42

Good afternoon, proteus experts. It is necessary to make a slot in the board (dielectric barrier). Previously, I didn’t design the board in the proteus, I can’t find how it is done.

Reply

Answer the question

In order to leave comments, you need to log in

1 answer(s)

A

Alexey Kudinov, 2020-07-13
@dinosaur2000

Roman, good afternoon. Didn't understand?

Similar questions

N

Neanderthal2015-11-19 17:22:19

Where in St. Petersburg can you urgently produce printed circuit boards? 2Reply

E

Evgeny Zubkov2015-12-24 16:57:26

Ordering printed circuit boards in China? 4Reply

A

AiR_WiZArD2020-07-12 08:26:01

3-channel DC-DC, voltages do not rise. Where did I make a mistake? 1Reply

A

ADRian2014-11-27 06:15:50

Is it possible to order multiple boards on one board from Dirt Cheap Dirty Boards? 3Reply

I

ilyageekdays2021-01-29 13:07:41

Where can I get PCB design standards? 1Reply

Didn't find what you were looking for?

Ask your question