How to make a network reservation for ether and wifi routeros?

Question

Mikrotik

Good afternoon! I invent "castle"!
There is an ip intercom and a very flimsy cable goes from the switch to this intercom (it is not destiny to change it, since the customer has already repaired it). The link with the intercom periodically disappears (once every 2-3 months), it was decided to put Mikrotik mAP between the switch and the intercom (with 2 ether and wifi).
I plugged a suite into ether 1, an intercom into ether 2 and connected to my home network via wifi in case ether1 falls off.
Assigned the address ether1 192.168.1.93, wlan1 192.168.1.94.
In route, I added the route ether1 distance 1 and wlan1 distance 2. And added all the ports eth1 eth2 wlan1 to the bridge. Everything basically works, but I noticed that a lot of traffic goes through wlan1 and eth1. How can I get rid of this and am I doing everything right? Or do I need to write scripts to disable and enable ports by ping?

Answer 1

And from a switch at you the smoke does not bring down? This is the natural ring you got. It's strange that it works at all.
Switch and home vlan router understand? You need to move towards l3.

Answer 2

I would rather write a script for raising WIFI, namely a WIFI connection, and not a route for the unavailability of a ping of the main gateway from eth1
so that a: not to load the air with a permanent useless device. b: do not fence all sorts of distances, etc.
In general, before repair, it is highly desirable to drag the entire hospital to normal CAT6-7, so as not to encounter such crutches