How to solve the problem with visibility behind Mikrotik?

Question

WiFi

Good day,
There is Mikrotik RB951G-2HnD v.6.34 - router
All computers see each other normally, they go to the Internet, everything is fine here.
There was a need to connect a remote client to it.
Took point Mikrotik RBwAP2nD v. 6.34 and connected it to Wi-Fi bridge mode with a router.
I see a point connected to the router, I can manage it, it receives IP from the router via DHCP.
The point sees everyone, goes to the Internet.
If I connect to the point with a cord (Wi-Fi holds the bridge), I also get an IP from the DHCP router, I see all my devices in WinBox, but I can only connect to the point and I don’t see the Internet. Nobody can connect to me or just ping me. It feels like there is no route.

Answer 1

On wAP, add both interfaces to the bridge, wifi to station bridge mode, be sure to disable the DHCP server. In this case, the dot should be transparent and no additional settings are required. If you don’t want transparency, then remove the bridge, wifi in the station, in the NAT rule with out-interface=wlan1 action=masquerade, on the DHCP server lan port. But to me, it doesn't make much sense.