Answer the question
In order to leave comments, you need to log in
P
P
Pypkin2014-12-20 22:14:49
Pypkin, 2014-12-20 22:14:49
How to know UART speed?
Is there any way to find out at what speed the UART is operating from the rx channel diagram using the "SignalTap II Logic Analyzer" logic analyzer?
The remaining UART settings are known (data, stop_bit, parity).
The diagram shows that the message is being transmitted (as it should be), but PuTTY does not show anything. I also used Tera Term - it also does not see anything. The method of scientific "poke" (enumeration of different speeds) did not give anything.
Could the problem be in the cts/rts signals that are present in the project and landed on the ground, but the FlowControl (in PuTTy) is set to none?
Similar questions
V
A
Alexey Sviridkin2015-01-06 02:46:15
Raspberry Pi b+ heats up but won't start. What is the reason?
3Reply
A
E
eegmak2021-03-27 22:40:09
What console utility to transfer data to the usb-uart adapter in linux?
4Reply
K
Didn't find what you were looking for?
Ask your questionAsk a Question
731 491 924 answers to any question