How to install windows server 2012 r2 on HP DL380e Gen8?

Question

RAID

Good afternoon.
The second day I'm fighting with the server, I can't install Win Server 2012 on it .
The essence of the problem:
I bought a new HP DL380e Gen8 server. It was decided to install Win Server 2012.
There are 8 disks of 1TB each. I create two arrays RAID1 (1Tb) and RAID1 + 0 (3TB) I
updated all the software by downloading HP SSP on 06/05/2015.
Through Intelegent Provision I start to install a server from the original disk. I installed everything as it should be, and during the first boot an error occurs (blue screen) and the server reboots, after several attempts it gives an error 0xc0000001.
I understand that the controller of the array sins, because if I disable it in the BIOS controller and install the server just on the disk, then everything works fine
. Question: how to solve this problem?
Thanks in advance.

Answer 1

Try to install the native disk controller driver on a flash drive before installation.

Answer 2

And if you put it on a separate disk with the controller turned on, wait for the drivers to be updated and clone the system for raid.

Answer 3

In the settings of the raid controller, when you assemble RAID1 on which the system, set the value of the Maximum Boot partition parameter to Enable (8GB maximum) in the lower right corner.