How to install and run Gnome on ArchLinux ARMv7 from console?

A

Andrey Meleshko2014-07-14 11:41:50

ARM

Andrey Meleshko, 2014-07-14 11:41:50

Following the instructions archlinuxarm.org/platforms/armv7/samsung/samsung-c... installed ArchLinux ARMv7 on a flash drive, but the graphical shell either does not exist or does not start, only the console. Please help me figure out how to make Gnome boot by default. If possible, point by point, since I'm new to Linux.

Reply

Answer the question

In order to leave comments, you need to log in

1 answer(s)

X

xotkot, 2014-07-14
@xotkot

where else will there be a graphical shell in an image weighing 160mb, only the most basic is put there, and everything else is delivered from rap.
> I'm new to Linux.
I think it's too early for you to put Arch and even on arm, without having at least some experience with Linux behind you.
If you already want to test your strength so much, then try to start a clean Arch on a virtual machine and then most of the questions will disappear by themselves.