How to implement dialer on freepbx?

Question

Asterisk

Hello!
It is necessary to implement automatic dialing, on freepbx.
Himself, using the magic poke method, I figured out that you can set up an outgoing route, where you can specify the trunks and specify the action when the caller picks up the phone.
But how to implement the launch of that same dialer?
Suppose the situation is:
There is a number [phone], which you need to call from all trunks in turn, specified in the outgoing route, and perform the action specified in this route (read a voice message, for example).
Attention, the question is: how to do it?
PS: I ask you to do without throwing slippers, from the category of "freepbx is bad", because freepbx is fundamentally needed, because of some modules that are only for it.
Or "read the book "IP telephony is the future". I'm sure the implementation is not as complicated as it seems to me.

Answer 1

I don’t know how relevant this is for freepbx, but for a bare asterisk I used call-files , perhaps it will be just as useful for you.

Answer 2

You can use call files and hang the task in cron.
See the use of callfiles at this link:
https://voxlink.ru/kb/asterisk-configuration/call-...