How to enable IGMP v3 on cisco 2960?

J

jidckii2015-09-21 12:16:10

Computer networks

jidckii, 2015-09-21 12:16:10

Actually a subject.
V2 by default, but did not find how to activate V3 in a specific VLAN.
From English. not very good, so I didn’t go to the cisco website either ...

Reply

Answer the question

In order to leave comments, you need to log in

2 answer(s)

Z

zorruch, 2015-09-21
@zorruch

the tsiska has a remarkable help in the console.
Can you try pressing the tab or ? (question mark) in the igmp configuration console and find the answer there.

A

Alexander, 2015-09-23
@NoOne6

For starters, IOS must be 12.0(15)S or newer, it will start on any platform, i.e. on 2960 too.
(IGMPv3 is supported on all Cisco IOS Release 12.0(15)S platforms and later releases.)
The Magic Commands Actually.
switch(config)# vlan vlan-id
switch(config-vlan)# ip igmp snooping explicit-tracking
(Tracks IGMPv3 membership reports from individual hosts for each port on a per-VLAN basis. The default is enabled on all VLANs.)