How do you label sockets and ports in switches?

Question

Documentation

There is a task to mark the cable from the socket to the switch. Actually how to number? Through? Do I need to include the floor, office, building, etc. in the numbering? Any advice from your experience?

Answer 1

As convenient as it is, just make a network map to make it easier to read

Answer 2

SCS label, in the sense? Floor-room-number. And the cables in the switch are usually marked by the device on the second side of the connection.

Answer 3

I did through numbering before driving on the patch panel, the numbers were unique, after driving the panel was numbered with a marker or sticker, then sockets were applied to the floor map according to the number on the patch panel (for example 1.34) well, in the offices they were signed according to No. p.p. . or on special markers, or a marker if the sockets are deshman.

Answer 4

We mark as follows:
Ypr-01-101-02
Control building, floor 1, room 101, workplace 2

Answer 5

Don't forget to just make intermediate markings. This helps to avoid many problems in the future.