Creation of a universal stand?

Question

Iron

There was a need to create a universal stand, such that a variety of motherboards and hot access to hardware could be placed on it without any problems
.
So far, the only thing on your mind is to make some kind of slider for the motherboard racks and, depending on the motherboard, move them back and forth?
Well, I'll be glad to see examples of self-made stands for iron.

Answer 1

Motherboard mounts are standard.
All case manufacturers have been successfully solving your "problem" since the last century.
You can take the motherboard mounting panel from the old case - all the holes are already cut out there as needed.

Answer 2

www.ixbt.com/editorial/aiwa/images/05.jpg
Take an ordinary piece of fiberglass sheet, take racks for boards - there are metal, plastic racks of different heights. You can even mount one board over another, the main thing is that there is enough cooling.
All this is sold in almost any adequate radio store, for example:
www.kosmodrom.com.ua/prodlist.php?name=fixfasten
www.platan.ru/cgi-bin/qweryv.pl/0w42802.html
For fastening - you can either use any plastic sheet - drill holes for your boards, and make a universal one. Or you can even take some case, disassemble it, throw out the excess, leave only the wall for mounting

Answer 3

Well, I'll be glad to see examples of self-made stands for iron.

Foam rubber or polystyrene foam from the packaging of sufficient height so that additional boards do not reach the table with their spout. The size is appropriate. On the reverse side of m.p. Enough protruding legs to prevent slipping.

Answer 4

At one time I glued clothespins to the table on a thermal gun, that's the whole "stand".