Configuring bond and vlan openvswitch Proxmox?

Question

openvpn

Good afternoon, Colleagues. I ask for help with the Proxmox issue, namely the correct network configuration (OpenVswitch).
So: there is a working network (vlan10, network 192.168.100.0/24 and vlan20, network 192.168.10.0/24), there is a managed switch, 2 ports of which are configured in the LAG, this vlan pair (10,20) was put into the ready bond.
There is a server, 2 ports (out of 3) of which are connected to the aggregated trunk ports of the switch. Raised pure Proxmox 5.1, updated, installed the openvswitch module.
By default, after installation, Proxmox takes a port with the Internet and creates a Linux bridge, prescribing an IP on the created bridge, on which, in fact, it is available (for example, 192.168.100.1, web).
If I take 2 ports, configure ovs-bond, ovs-bridge (indicating the previously created bond and vlan received from the switch as ports, trunks=10,20), set the OVS bridge IP from the vlan10 subnet (let's say 192.168.100.2) , delete the Linux bridge and IP created by Proxmox, then I lose access to Proxmox.
Can you tell me what I'm setting up wrong?

Answer 1

Go to proxmox and see what's wrong