Cisco EEM does not respond to syslog messages. What is the problem?

Question

System administration

I configured sla icmp-jitter on the tsiska, in which 100 packets are sent once a minute.
Set up a reaction to this sla:

ip sla reaction-configuration 2 react packetLoss threshold-value 10 1 threshold-type immediate action-type trapOnly

if more than 10 packets are lost, a log message is generated.
A message to the log is generated, and not even one:

33675893: Mar 25 16:50:54: %RTT-3-IPSLATHRESHOLD: IP SLAs(2): Threshold occurred for packetLoss
33675894: Mar 25 16:50:54: %RTT-3-IPSLATHRESHOLD: IP SLAs(2): Threshold exceeded for packetLos

I set up EEM, which, based on the message in the log, must perform certain actions (for example, the most banal actions are to write a message to the log):

event manager applet test
event syslog pattern "%IP SLAs(2): Threshold occurred for packetLoss"
action 1 syslog msg "EEM test completed successfully"
action 2 cli command "end"
action 3 cli command "exit"

And so this EEM for some reason does not work. When there is a reaction to the SLA, a message appears in the logs, but EEM does not want to work based on this message. What could be the reason?