USB Hub started to work slowly, how to fix it?

Question

Iron

Model Transcend TS-RDP7W. I insert it into usb2.0 and writes as if I connected it to 1.0 and says that I need to insert it into 2.0. I also have this picture prntscr.com/b826r2 In addition to the general tab, there is nothing in all devices, not only here. Can put the driver on usb controllers? But how do you know which ones? When copying, the speed behaves strangely, although the maximum speed of the flash drive is approximately 16mb, at the beginning of copying it is about 100 and then gradually drops to almost 0.5mb. When I insert a USB flash drive without a USB Hub, then the story is the same, but the speed drops to about 16 MB.
What do you advise? Are they viruses or drivers?

Answer 1

update drivers for mother or usb.