Setting up zabbix (2.2) + zywall usg 300

Question

Zabbix

Good afternoon!
there is a zywall usg 300, snmp is configured in it (configuration-> system-> snmp-> enable)
there are standard settings
server port 161
get c.-public
set c.-private
for all zones and all addresses allow (rule)
in the documentation ( ftp://ftp.zyxel.com/ZyWALL_USG_300/user_guide/ZyWALL%20USG%20300_2.0_Ed2.pdf p.608) found OIDs:
1.3.6.1.6.3.1.1.5.1 (port 1 at the end, for monitoring)
1.3. 6.1.6.3.1.1.5.3 (link down)
1.3.6.1.6.3.1.1.5.4 (link available)
1.3.6.1.6.3.1.1.5.5 (for admin commands)
When I specify snmp v2 agent item in zabbix
and I enter the key 1.3.6.1.6.3.1.1.5.1 and communtity (private), then zabbix seems to start receiving snmp packets from the hardware, but after a while it falls off due to "No Such Object available on this agent at this OID"
Error due to wrong OID?

Answer 1

These are trap OIDs, that is, the fire itself sends this to the device specified in its configuration (on page 608, the interface for setting the trap assignment is shown). On the monitoring server, you need to configure something like a trap handler so that when you receive 1.3.6.1.6.3.1.1.5.3, zabbix reports a problem.
Thus you cannot query information from an OID that is an SNMP Trap.'
By the way, 1.3.6.1.6.3.1.1.5.5 - authenticationFailure will be sent when authentication fails on the firewall :)
Good luck!