Categories

JavaScriptPHPHTMLCssPythonWordPressWeb developmentLinuxMySQLAndroidWindowsJavaC++ / C#LayoutReactUbuntuYiiDjangoProgramming1C-BitrixLaravelSystem administrationTelegramJSONDebianPostgreSQLIOSGoogleHtaccessWindows ServerGitMacOSGoogle ChromeCMSWooСommerceBootstrapNginxSQLUnityAPI
Make a leaderReport
V
V
vfvnvsyevsky2014-10-17 12:52:59
Denver
vfvnvsyevsky, 2014-10-17 12:52:59

How to remove localhost/ from the address bar when using mamp and going to a local site?

Recently switched to mac os and found a replacement for denver in the form of mamp. But ran into a problem. When using Denver, it was necessary to write in the address bar of the browser only the "supposedly" address of the site (sayte.ru for example.) And in mamp you need to register localhost and the directory where the site is located. How to make everything work like Denver?

Reply
Answer the question

Answer the question

In order to leave comments, you need to log in

0 answer(s)
Similar questions
O
olegmalofeev2015-01-23 16:06:03
What is better XAMPP or Denwer for further installation of Bitrix and WordPress? 8Reply
D
dimavfox2019-06-21 12:06:08
Why does Denver redirect to "Hooray, it worked!"? 0Reply
S
Snatch082019-09-09 16:09:47
What about subdomains? 2Reply
T
terminator482015-05-28 18:30:30
Why can't CMD run as administrator see the virtual drive connected by Denwer? 1Reply
W
wolfak2015-06-16 12:58:08
Denwer for email newsletters? 3Reply

Didn't find what you were looking for?

Ask your question

Ask a Question

731 491 924 answers to any question