How to remove callerid hiding on cisco 3825?

Question

Cisco

Good afternoon.
There is such a switching scheme available:
from cisco 3825 (Version 12.4 (24) T7) on the E1 stream, the PBX is turned on. With automatic telephone exchange all calls fly with hidden callerid.
Cisco sees it like this:

Progress Ind i = 0x8283 - Origination address is non-ISDN
Calling Party Number i = 0x21A1 , '2223322'
Plan:ISDN, Type:National
Called Party Number i = 0x80, '89236669999'

When this call is made from a cisco via sip to asterisk, then callerid(num) already comes anonymous.
How can I change the Calling Party Number parameters so that callerid is not restricted?
When I include another PBX in the cisco, where calerid is not hidden, the call looks like this:

Progress Ind i = 0x8283 - Origination address is non-ISDN
Calling Party Number i = 0x2181 , '2223322'
Plan:ISDN, Type:National
Called Party Number i = 0x80, '89236669999'

The settings on the cisco are:
!
controller E1 0/0/0
framing NO-CRC4
pri-group timeslots 1-31
!
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn timer T303 6000
isdn timer T310 55000
isdn not-end-to-end 64
isdn protocol-emulate network
isdn incoming-voice voice
isdn calling- party-num network-provided
isdn negotiate-bchan resend-setup cause-code 34 44 47 102
isdn reject data
isdn reject v120
isdn reject v110
isdn reject piafs
no isdn gtd
trunk-group 1
no keepalive
no fair-queue
no
Dialpir towards asterisk:
!
dial-peer voice 201 voip
tone ringback alert-no-PI
description Out_Leg-All-to-ASTER
preference 1
destination-pattern .*
voice-class codec 100
session protocol sipv2
session target ipv4:192.168.1.50
ip qos dscp ef signaling
no vad
!