How to properly configure bgp over dmvpn?

Question

Cisco

Good afternoon, bgp works through the ip vpn service of one of the providers, it became necessary to reserve these channels through dmvpn with the possibility of load balancing, but attempts to configure the view
neighbor 10.255.3.6 remote-as 65012led to a loss of control over the dmvpn hub router, an attempt to configure the reflector route leads to the following:

address-family ipv4 
 neighbor 10.255.3.6 remote-as 65012
  neighbor 10.255.3.6 activate
  neighbor 10.255.3.6. route-reflector-client
% Invalid command. Not an internal neighbor

Answer 1

Well you are asking a question. It's hard to guess from three commands) As for the router reflector, the problem is most likely that you are trying to get to it from another as.
And so podebazhte - try without RR, without dmvpn.