How to make on Mikrotik so that the physical network and virtual (VLAN) see each other?

Question

Mikrotik

Good day to all!
There is a Mikrotik router and a switch managed by 2 levels D-link DGS 1100-08
Mikrotik has 2 port configured for the provider, 3 PC port, 5 port goes to 1 long port.
The fact is that I set up subnets and they do not see each other, there is no Internet on the VLAN .... I tried routing through Routers, and nothing happened .... Tell me, kind people, how to correctly register the route and NAT so that the networks see each other and there is the Internet.
Settings:
Physical network configured (brigde) 192.168.1.0/24 (DHCP is also configured and DNS)
VLAN (ID 5) is configured (SW) to subnet 192.168.88.0/24 (DHCP and DNS are also configured)
Tried this route:
Dst. Address 192.168.88.0/24 (VLAN subnet)
Gateway 192.168.1.1 is the gateway of the router (Not from the provider)
Check Gateway PING
Type: Unicast
also did it with the subnet of the physical network ... I registered it the other way around. What is wrong?)
NAT settings in the firewall:
Chain: sncnat
Dst. address: 192.168.88.0/24
Action: masquerade
Here) And nothing .... What else can be missing? In fact, I didn’t do anything else in the router (everything else seems to be default).

Answer 1

you should have tagged on port in d-link, and untagged on port 5 in Mikrot. and on Mikrot, the VLAN you want to be friends with a certain network must be in the same bridge . And then there are the routes.

Answer 2

Tl;dr
Hasn't changed anything, I recommend to paint in more detail what you really want. And why a masquerade is needed for addresses in vlan is a mystery to me. It smells like overengineering.
Regarding the essence of the issue - usually enough necessary interfaces (vlan, vpn, ethernet, wifi ..) stupidly put into the bridge and AUTOMAGY will work inside Mikrotik